top of page

ADENA Hack: How to configure CI-series cameras in the Tracking Config Tool

All CI-series tracking cameras rely on the Tracking Config Tool for tracking configuration. Using this tool, you are able to change tracking modes, tracking directions, auto-zoom presets, tracking and zoom offsets, set up custom zoom levels for tracking, and also update tracking firmware. In order to configure these tracking settings of your camera, you need to use the provided USB-3.5mm cable. Connect the USB to your computer and the 3.5mm end to the camera’s 3.5mm jack - for CI-T21H, this will be on the top of the camera, whereas for CI-T10 it will be on its back. After the cable is connected, open the Tracking Config Tool. On the left side from the list of Ports, select the COM port called “Prolific”*, then press “Connect”. All tracking settings will be enabled to you and you will be able to change them how you see fit. After you make the necessary changes, press “Apply” and disconnect the tool. Using the Tracking Config Tool is simple and fast, and allows you to make the tracking ideal for your location. If you would like to know more or need assistance, reach out to us at and we will be glad to help you.

*Please note that if you do not see “Prolific” COM port in the port list, you will need to download it from our website



bottom of page